Method for pasting polymer protective film on car

One of the protective films of the wholesale polymer protective film is used in automobiles, and there are two ways to paste it, namely dry pasting and wet pasting. Let’s take a look at the wet pasting method today. The wet sticking method uses a watering can, a scraper, a clean rag, a blower, a utility knife, etc. Two people must cooperate during the operation. First, clean the surface to be pasted, and spray glass water evenly on the surface to be pasted. This is mainly used to reduce the viscosity of the sticker and facilitate adjustment of the position. After determining the position, lift it up from right to left together with the car sticker, and press it on the car watch with a rag, and flatten it with the rag while sticking it. It should be adjusted in due course, and the water and air bubbles should be repeatedly scraped off with a scraper. Separate the door and the seam with a utility knife, and paste it inward. There is a small suggestion after pasting, that is, do not expose to the sun within 24 hours, and do not wash the car within 48 hours, which can make the performance of the protective film better. Next: The principle and advantages of PE heat shrinkable film Previous: The packaging characteristics of PE heat shrinkable film