Difficulty in peeling off PE heat shrinkable film

PE heat shrinkable film manufacturers’ products are difficult to peel off, mainly because the protective film does not use a special adhesive, and the protective film belt is too soft to withstand the tension when it is torn off. To solve this problem, you must start from the foundation and replace the pressure. Sensitive glue or replace the main belt material of the protective film. The current society’s requirements for environmental protection are getting higher and higher, and people’s awareness of environmental protection is also getting higher and higher. At present, products have relatively high requirements for environmental protection. Generally speaking, the future of products with good water solubility has good market prospects. . As the width and length of the protective belt increase, the difficulty factor will increase slightly. Align the PE protective film perfectly on the surface of the object, so that the surface will not produce unsightly wrinkles and bubbles, especially on irregular product surfaces that are difficult to handle. In order to put a better protective film on the surface of the product and try to be perfect, we need at least two people. One person holds the reel of the protective film, and the other pulls the torn end to the opposite side of the product that you want to protect, sticks the end to the target surface, and pushes the protective film to the specified position by hand, facing the reel People. Next: Why does PE heat shrinkable film have crystal points? Previous post: Protective film brings great convenience to our lives