How to perfect PE heat shrinkable film

How does the PE heat shrinkable film manufacturer completely paste the protective film on the product surface: 1. Prepare a flat work space of appropriate size, clean and free of dust, liquid or pollutants. Paste 4.5 feet of double-sided tape near the ends of the workspace, about 8.5 feet away. 2. When the adhesive is upward, spread the protective film slightly. Make sure it is smooth and without wrinkles, and evenly paste the loose end on any one of the double-sided tape. Continue to unfold the protective film and place it along the length of the working surface not far from the double-sided tape on the other side. 3. Now roll up the film and place it on top of the double-sided tape. Be careful not to pull the original connection end out of the tape. Adjust the direction of the film to ensure that the film is flat and free of wrinkles. However, the film will shrink later. 4. Place the film on the second double-sided tape. Using a utility knife, cut the roller from the film waiting to receive the protective sheet. Place the edge of each piece of material on one side or one side of the protective film, and place the film on the position clamped by the double-sided tape. 5. Place the part on the adhesive film. To ensure that the sheet adheres to the film, pressure is applied to the material, especially to ensure good adhesion along all edges. A clean paint roller may be used for this purpose. 6. Use a utility knife to trace a part of the outline on the protective film, cut off the excess film, and delete the excess. Turn the part carefully, apply pressure directly to the film if necessary, and work from the middle to the outside to ensure the tightness of the entire area. Next: The advantages of using PE heat shrinkable filmPrevious: Problem analysis and solutions of PE heat shrinkable film