The reason why the protective film is difficult to peel off

Under the large-scale development of wholesale of polymer protective film, protective film has been well applied. However, it is very difficult to peel off the protective film after use, which also caused us a lot of trouble. Today the author will tell you the reasons why the protective film is difficult to peel off. The protective film product is difficult to peel off. This is an experience that everyone has experienced. When the profile product is installed and peeled off, the protective film cannot be effectively peeled off. There are two reasons for this phenomenon. One is that the sensitive adhesive used in the protective film product is not protective. Special sensitive adhesive for film, the protective film is very effective when pasting, but it will be very difficult to peel off. This problem often occurs in the protective film produced by some illegal protective film product manufacturers. Another possibility is that the material used in the protective film master tape is too soft to withstand the tensile force during peeling, and breakage occurs during peeling, which is a very headache for users. The reason why the protective film is difficult to peel off is roughly the above two, so in order to avoid this phenomenon, you must buy the products of regular manufacturers when buying, so as to ensure its quality and facilitate our use. Next: The adverse effects of inferior high temperature resistant protective filmPrevious: What are the characteristics of stretch film